When using the Shimadzu autosampler, it was found that someone would set the sample to -1 and the injection amount to -1. Why are these?

Time:2018/08/28 Pageviews:6 Share:

This is an article about When using the Shimadzu autosampler, it was found that someone would set the sample to -1 and the injection amount to -1. Why are these. If you are interested, please contact us!

Answer: Do not inject, run the baseline

0.5dram 9mm screw HPLC vials

This is the end of the introduction of When using the Shimadzu autosampler, it was found that someone would set the sample to -1 and the injection amount to -1. Why are these. I hope it can help you.

Previous:Is the Waters HPLC vials common to the Shimadzu HPLC vials?

next:Sample vials of the core Silicon Valley?